- Solutions de roulements industriels
- Ridements à Roulements Cylindriques Complètes NSK Single-Row Tapered Roller Bearings NSK Yuken Piston Pump
Français
English
العربية
Deutsch
Ελληνικά
Español
Bahasa Indonesia
Italiano
日本語
Português
Русский язык
Shqip
Svenska
ไทย
Türkçe
Українська
- Adresse32 Jurong Hill, Singapour 628925
- Adresse Usine05 Stanley Street Central Hong Kong
- Le temps de travail9:00-18:00 pm
- téléphone professionnel(Temps de travail)+852(3)1591338
Taper Bearing Sets TIMKEN
Contacter maintenantTapered roller bearings are rolling element bearings that can support axial forces (i.e., they are good thrust bearings) as well as radial forces.
The inner and outer ring raceways are segments of cones and the rollers are tapered so that the conical surfaces of the raceways, and the roller axes, if projected, would all meet at a common point on the main axis of the bearing. This geometry makes the motion of the cones remain coaxial, with no sliding motion between the raceways and the OD of the rollers.
This conical geometry creates a linear contact patch which permits greater loads to be carried than with spherical (ball) bearings, which have point contact. The geometry means that the tangential speeds of the surfaces of each of the rollers are the same as their raceways along the whole length of the contact patch and no differential scrubbing occurs.
The rollers are stabilized and restrained by a flange on the inner ring, against which their large end slides, which stops the rollers from popping out due to the "pumpkin seed effect" of their conical shape.
The larger the half angles of these cones the larger the axial force that the bearing can sustain.
Tapered roller bearings are separable into a cone assembly and a cup. The non-separable cone assembly consists of the inner ring, the rollers, and a cage that retains & evenly spaces the rollers. The cup is simply the outer ring. Internal clearance is established during mounting by the axial position of the cone relative to the cup, although preloaded installations without clearance are common.
| Bearing Number | Bore Dia | Outer DIa | Width | Size |
|---|